Welcome
Hardware OverviewHardware Overview
- Hardware overview
- Semi-demountable torch assembly and disassembly
- Install the torch
- Assemble the nebulizer
- Setup the sample introduction area for use
- Start the ICP-OES and ICP Expert software
- Prepare the calibration solution
- Perform an instrument calibration
Software OverviewSoftware Overview
- Software overview
- About the Start page
- Configuration page - Enable worksheet options
- Elements page - Select and setup elements
- Conditions page - Setup Analysis Conditions
- IEC page - Setup and run a method with IEC
- Standards page - Enable and configure standards options
- QC page - Setup a method with QC tests, expanded QC, and expanded QC with USP and ICH support
- Sequence page - Setup the Sequence and QC tests
- FACT page - Setup a method with FACT background correction and create and view FACT libraries
- Autosampler page - Enable and configure the autosampler
- Analysis page
- IntelliQuant analysis and screening methods
Set up the InstrumentSet up the Instrument
- Semi-demountable torch assembly
- Setup the sample introduction area for use
- Starting the ICP-OES and ICP Expert software
- Prepare the calibration solution
- Perform an instrument calibration
Create a MethodCreate a Method
- Create and open a worksheet
- Setup a basic quantitative method
- Setup a method with QC tests
- Setup a method with Expanded QC
- Setup a method with Expanded QC and USP 232/233 and ICH Q3D support
- Setup a method with IEC
- Setup a method with FACT background correction
- Setup a method with Autodilution
- Setup a method with IntelliQuant
- Setup an IntelliQuant Screening method
- Maintenance checklist
- Maintenance log
- Clean the snout
- Clean the cone
- Clean the torch
- Clean the spray chamber
- Clean the nebulizer
- Replace and adjust the peristaltic pump tubing
- AVS 4, AVS 6, and AVS 7 maintenance and replacement procedures
- Clean the 5100/5110 air inlet filter
- Replace the 5800/5900 air inlet filter
- Clean the instrument water filter
- Clean the ICP-OES
- Replace the axial pre-optics window
- Replace the radial pre-optics window
- Cleaning the pre-optics windows
- Replace the optics purge gas filter
- Induction coil maintenance